Kirkland · Wolf
Wolf Gas Cooktop Burner Repair
Wolf gas cooktop repair: spark ignition, sealed burners, burner valves and the knobs that drive them.
What people call us about
- One burner lights, but its flame lifts off the ports or burns yellow
- Sealed burner simmers fine but will not climb to full output
- Every burner sparks at once whenever a single knob is turned
- The lowest simmer setting goes out after a minute or two
How the visit runs
- Read us the model number It is on the cooktop’s rating plate. Say which burners misbehave and what each one does — no click, a weak flame, a simmer that dies — and the likely part is usually clear before the visit.
- Checked burner by burner Spark at every electrode, the flame at Hi and at the lowest setting, and the gas arriving at each valve. The finding is something you can watch on the burner, not a label.
- A price, then a decision Parts and labour arrive as a single number. Say yes, say no or sleep on it — stopping there costs the $89 service call and nothing more.
- Lit again before we go Every burner is lit and turned from Hi down to simmer once the repair is done, and the same checks are repeated while you watch.
What it costs
What cooktop repair runs in Kirkland
A flat $89 pays for the visit and the whole diagnosis; approve the repair and that $89 comes off its price.
Each band is the spread we see for that kind of job on a Wolf cooktop, not a starting price. Two things decide where yours lands: the revision of the part your serial number takes, and how far into the cooktop the work has to go. Either way, the figure is given to you — parts and labour together — before a screw is turned.
- Igniter or spark module
- $180 to $440
- Burner valve or orifice service
- $240 to $580
From Kirkland kitchens
What people say afterwards
4.9 / 51,601 reviews
Front left simmered fine but never climbed to full output. He cleared an orifice that had been partly blocked from the day it went in, then checked pressure at the manifold. Boils a pan properly now.
Whitney L.
Touch panel beeped at every press but nothing switched on. A cracked ribbon connector under the glass, not the board he had been told to expect. He sourced it and came back to fit it days later.
Erik B.
Turning one knob set all five burners clicking at the same time. He changed the ignition module and dried out a switch a boil-over had got into. Now only the burner I am using clicks.
Mona S.
Book the diagnostic
Name the burner, the knob and what it does.
Read us the model off the rating plate and describe the flame, the click or the smell. The visit is a $89 service call that comes off the bill if you go ahead, and the repair figure is agreed before a panel is lifted — anywhere in Kirkland.
Visits 8:00 am – 8:00 pm, seven days · calls taken 24/7